View Single Post
Old 09-16-2018, 06:45 PM
mrvette's Avatar
mrvette mrvette is offline
United States | Phantom of the Opera
Join Date: Mar 2008
Location: NE Florida
Posts: 15,302
My Photos: ()

Long as yawl under there, I would like to know the height from drive yoke output sleeve at bottom, to bottom of the cross support...

like this 0

the in between distance on mine is 5"
to this _

at 80 mph at ~2400 rpm with 336 rear and .70 overdrive 200 r4 auto the shifter is mounted to the cross support....I feel a LOT of vibration in the handle....not a GROSS amount, but alot more than I would I thinking of driveshaft angles on the vertical plane.....

ALSO, on that cross support, is the center section where the trans sets a different height than the two section outside of the exhaust loops?? reason is that I modified hell outta my cross support and I wonder if I screwed it up.....

"Hell, there are no rules here ... we're trying to accomplish something." Thomas Edison
I have a little list, let ALL of them be MIST......
Reply With Quote