J56 bracket drawing?

I saw these and since I bought a mill, figured I'd make a set. Does anyone have a drawing? If not, I'll post something up after making a set. I'm leaning toward using 6061, but may go with steel.

I'm pulling the hubs anyway to upgrade to 1/2 in studs.

Model in the download section:

http://www.vettemod.com/forum/downloads.php?do=file&id=105

Thanks, I have never done much with CAD. Might have to start.

there is a guy in TX who has a bunch of them on ebay, I know he`s a CF member but might also be a member here, John Bulba he was selling them for cheap...nice guy too, he might sell you a set.

redvetracr said:

there is a guy in TX who has a bunch of them on ebay, I know he`s a CF member but might also be a member here, John Bulba he was selling them for cheap...nice guy too, he might sell you a set.

Click to expand...

Yeah, thanks. That's most likely his photo. I think it was Ebay where I found it.

I own a mill now, so making the parts justifies the purchase.

I think they were asking $200 to $300.

I'll make a sketch and post it after completion.

I have a gen I concept that is about 1/2 done. It turns out the new stamped steel brake brackets are thicker, so to make these work on any car, they need to be fitted.

I will put the rest of the info in my thread in the chassis section later.