I need to merge shorty headers on a BB Corvette with Magnaflow pipes on a car that does not have a body on it. Wanted to make sure I cleared the floor of the car, oil filter and starter and have the pipes no lower than the oil pan. So I built this 2x4 holding fixture that maintains alignment from the header flange to the crossmember tubes that the pipes go through.
Noe that I have this I'm thinking I could use it to make some long tube headers!
![45b4e23ae73ff0.jpg 45b4e23ae73ff0.jpg](https://www.vettemod.com/data/attachments/46/46972-8c85d8f50ef5914810f4e896a749512d.jpg)
![45b4e23ae90090.jpg 45b4e23ae90090.jpg](https://www.vettemod.com/data/attachments/46/46973-4fb6fdc4db2816f13be88ceaf1e32ca4.jpg)
Noe that I have this I'm thinking I could use it to make some long tube headers!
![45b4e23ae73ff0.jpg 45b4e23ae73ff0.jpg](https://www.vettemod.com/data/attachments/46/46972-8c85d8f50ef5914810f4e896a749512d.jpg)
![45b4e23ae90090.jpg 45b4e23ae90090.jpg](https://www.vettemod.com/data/attachments/46/46973-4fb6fdc4db2816f13be88ceaf1e32ca4.jpg)