mrvette
Phantom of the Opera
'72 vette 350 engine, 200 4r trans stock drive shaft/diffy....
so question is, how to measure the drive shaft angles?? kind of hard to do the diffy end, I expect, much less I confused what gear and HOW to do the trans end....the cross support is modified quite a bit so unsure of the height of it in the center, I think the trans mount makes the shaft quite a bit higher, but unsure of how much
I hear the input and output shafts have to be the same angle ...
:twitch:
so question is, how to measure the drive shaft angles?? kind of hard to do the diffy end, I expect, much less I confused what gear and HOW to do the trans end....the cross support is modified quite a bit so unsure of the height of it in the center, I think the trans mount makes the shaft quite a bit higher, but unsure of how much
I hear the input and output shafts have to be the same angle ...
:twitch: