I bought a preformed stainless fuel line and tried to cut off the hose end and flare it for an AN fitting. That stuff is rock hard! I can't even get the clamp to grab the tube, it just pushes back out. If I did flare it, I'm guessing it would crack.
So I went online to find annealing methods for SS. I found something that, in general describes three different processes but not a "how too". Anyone done this?
http://www.azom.com/article.aspx?ArticleID=1141
So I went online to find annealing methods for SS. I found something that, in general describes three different processes but not a "how too". Anyone done this?
http://www.azom.com/article.aspx?ArticleID=1141