I have American Torque Thrust T-70R 5 spokes on my car, the rears have a 1/4 aluminum drilled to fit spacer to give my tire some room so when the wheels are mounted I don't have much stud to keep the wheel on....this is a problem ,I don't want the rim to fall off. I have looked on Corvette Forum posts claiming they can replace the studs by drilling a hole in the brake dust shield, I am installing 2.5 inch ones so I can use my rims. Has anyone done this before? I really don't want to take the trailing arm off to get the studs installed because I will have to replace the bearings, seals, etc..so if anyone can shed some light on this subject please do so!:shocking::shocking::shocking::shocking::shocking:
Last edited: