427 SBC Torque Monster

CNC BLOCKS

Well-known member
Joined
May 13, 2008
Messages
169
Location
Northeast
Spent some time on the dyno yesterday on a SBC 427 build for a good friend of mine. He wanted a SBC with BBC torque down low for his street build. This engine laid out some impressive numbers.

Was a very efficient engine only required 32 degrees of timing it did not like 34 degrees and it did not like 30 degrees.

This is what I came out with and it was no budget build LOL.

This is also on my F/B page with a lot of pics of the build https://www.facebook.com/cncblocks.northeast/posts/856106251235885?pnref=story

This will be the only one of these I will build I can take it off my bucket list as I have wanted to this build for a long time and it came out as planned.

Dart SHP block 3.875 stroke X 4.185 bore sonic tested 3 blocks and this one was the best one
.
Callies Comstar crank

Scat I beam rods 6.0

Custom Wiseco dished pistons.

Ultradyne HYD roller on a GM step nose core I used the GM spider and GM roller lifters reduced the base circle to 1.050 Lifters were quiet block need no oiling modification LOL

AFR 210 heads 75 CC chambers

Eddy Air Gap intake

750 Quick fuel carb, Wanted to go to a bigger High speed air bleed but the customer said leave it alone it was fine.

Scorpion 1.5 rockers

Champ 8 quart pan

10552 Oil pump
fp2g48.jpg

e5jw3b.jpg

29uvc49.jpg
 
Top