I think all C3's have all four headlights on (any time the headlights are on). When the high beams are on the second filament in the inside lights is switched on. I have replaced my lights with H9 lights that are single filament lights. I like the "look" of all four lights on but don't want to drive around with bright lights at all times.
So I am thinking that I could wire the outside 2 lights normally and the two inside lights in series to cut their power in half. Then the high beam would switch the two inside lights to parallel (and full brightness).
As I have said before, wiring is not my best subject. So what do you think?
EDIT: C3 don't have all 4 lights on as I thought.
So I am thinking that I could wire the outside 2 lights normally and the two inside lights in series to cut their power in half. Then the high beam would switch the two inside lights to parallel (and full brightness).
As I have said before, wiring is not my best subject. So what do you think?
EDIT: C3 don't have all 4 lights on as I thought.
Last edited: