Search results for query: *

After adding the gussets to the frame and dropping in a big block with a road race pan, I found out the ss transmission cooler lines For the 400 trans will not fit. First they hit the oil pan kick outs and then they hit the gusset on the motor mount. Is anything easy? Has anyone ran -6 braided...

I’ve seen throttle linkage brackets mounted there on stock manifolds

I know this is verrry old, but! Doesn’t e85 work like methanol? If so, you will use more e85 to go the same distance. So we’re is the savings? I had to get much larger pills and a bigger pump when I went to methanol. And does gas with ethanol 10% or? Eat up rubber. My 77 el Camino has not had...

Anyone running a gm type 2 power steering pump with v belts? I want one with a remote reservoir but there are so many out there and a lot of different part numbers. This is going on a 70 LS6 bb

Another American company gone, what a shame. Country is going done the hole and no one seams to care

So my understanding is, if the hose connection is in the valley that is part of the area below the thermostat than that will work. If so great, with a hose a little longer I can use a AN fitting.

Looks good

there are 3 holes in the intake for a heater hose. Can the bi pass hose go to the other 2, or does it have to be in the center hole directly under the thermostat?

What headers are you running?

I know this is old, but I have a question. Would it be a problem to run the bypass hose from the bypass hole in the water pump to a different hole in the intake? Say the heater hole to the left of the typical bypass hole in the intake. I am using AN fittings on everything and that short hose is...

Thanks

Needing to shim my rotors to get the runout dialed in. I cannot find and shims for this. After this virus BS you can’t seem to find anything anymore. Suggestions

Goes to show you, people need to think of this when they go vote and not vote for what is popular

Bonjour

😁

Car looks great! vettes were made to be black

Me too and if I knew that I would of got the powder coat. so I guess when I get my wheels, I will pull the calipers and powder coat to match the wheel center. I don’t like the silver, they We’re supposed to be like the one dark piece I got. I’ll make sure not to have wilwood on them either...

looks good, paint, anodize or powder coat?