cajos1968
Well-known member
Is there a trick to powder coat a hinging part without disassembling them? Simply taping off, will that work?
BTW: Do any of you guy's pre heat the object and then PC?
Cool, will try this week and see where this ends. Did you tape off any of the pivoting?
BTW: Do any of you guy's pre heat the object and then PC?
I almost did pc them until I bumped the hood support one day and I thought the damn thing was going to come down on me - I decided there and then that I wanted to piss it off and get a gas strut. I got the latching mechanisms chromed as I needed some bling in the engine bayCool, will try this week and see where this ends. Did you tape off any of the pivoting?
BTW: Do any of you guy's pre heat the object and then PC?
No i did not tape any thing off when i did it, your parts will still move just fine.
You must pre heat the part to out gas the metal,if you skip this step you will get a lot of tiny bubbles in the pc.
Wayne since you have pc every thing else,i am surprised you did not pc these parts