68VetteModified
Member
I have almost a complete set of parts for a rear 6-link setup (refer to the 6-link thread, post #214). The cut outs are stainless and the top and bottom strut mounts are Aluminum. This will save a lot of work if you are going this route.
I have the parts pictured for $800 + SH. (Top Picture)
I also have (2) sets of aluminum top and bottom strut brackets for $400 + SH per set. (Bottom Picture)
Note..... The parts are designed for Currie Enterprises Johnny joints. (CE-9112N-13). The holes for the heim joints are .562 dia., but other heim joints can be used with shims and spacers.
E-Mail me at [email protected] to answer any questions....Thanks.....Ken
I have the parts pictured for $800 + SH. (Top Picture)
I also have (2) sets of aluminum top and bottom strut brackets for $400 + SH per set. (Bottom Picture)
Note..... The parts are designed for Currie Enterprises Johnny joints. (CE-9112N-13). The holes for the heim joints are .562 dia., but other heim joints can be used with shims and spacers.
E-Mail me at [email protected] to answer any questions....Thanks.....Ken
Last edited:
