Want a bigger oil pan!!

[kwplot34]

Im in search of a higher capacity oil pan that will fit in the vette. The old factory pan has to go.
I have a Stroker SBC,so the pan needs to clear the bigger crank. Also my block is an (according to the casting #'s on the block) 86-87 chevy truck block,1 piece rear main.

So what do you guy's say?? which one to get???

 

[kwplot34]

What about this pan?
http://www.jegs.com/i/Milodon/697/30909/10002/-1?parentProductId=745507

or this pan??
http://www.jegs.com/i/Trans-Dapt/969/0218/10002/-1?parentProductId=760854

 

[Twin_Turbo]

That's similar to the one Xander has (2pc main seal), excellent pan.

 

[kwplot34]

That's similar to the one Xander has (2pc main seal), excellent pan.

Which one TT the Miliodon or the Hamburger pan?

 

[Twin_Turbo]

milodon :thankyou:

 

[kwplot34]

milodon :thankyou:

Thank you TT. Your brother has one just like (except his is for a 2 piece) it,no clearance problems? I will probably need a new pickup tube for the deeper pan,correct?

 

[Twin_Turbo]

yes, the correct pickup is available from milodon.

 

[kwplot34]

yes, the correct pickup is available from milodon.

Thanks TT found the pickup for that pan. New pan,pickup,fel-pro 1 piece gasket,oil pan studs(ARP) are all on order.

Thanks again for the help TT :thumbs:

 

[Twin_Turbo]

your 1 pc roller motor should already have a 1pc reusable gasket from the factory. They're normally gray, no use to buy a new one if the old one is reusable.

 

[GT6Steve]

I have a BRAND NEW milodon #30901 pan and extended pickup I didn't use if you want to make a deal. It's just occupying space here....:crap:

 

[kwplot34]

I have a BRAND NEW milodon #30901 pan and extended pickup I didn't use if you want to make a deal. It's just occupying space here....:crap:

I would take you up on that offer,BUT, i need a pan for 86 and up,and that pan fits up to 85. :crap: