MYBAD79
Moderator
Some time later this year I'll disassemble the trailing arms again and replace the spindles and wheel bearings.
I replaced the trailing arm bushings with poly back in 2004, depending on their condition I might reuse them or install rubber or johnny joints... not sure yet...
anyways.... I'd like to reinforce the front of the trailing arm like it was don here:
.

.

who posted this and is this a johnny joint or what ?? doesn't look like the standard bushing sleeve setup...
Rather than buying two new arms I'll reinforce the front, rear and possibly add tubes like TT did..... I have a sandblaster, a welder, beer and a plan.....
How much are johnny joints ? The price tag might make my decision easier....
I replaced the trailing arm bushings with poly back in 2004, depending on their condition I might reuse them or install rubber or johnny joints... not sure yet...
anyways.... I'd like to reinforce the front of the trailing arm like it was don here:
.

.

who posted this and is this a johnny joint or what ?? doesn't look like the standard bushing sleeve setup...
Rather than buying two new arms I'll reinforce the front, rear and possibly add tubes like TT did..... I have a sandblaster, a welder, beer and a plan.....
How much are johnny joints ? The price tag might make my decision easier....