Exhaust

[COLE SWEAT]

Where can I get 3” exhaust for my 69? I don’t want the mufflers, just the pipes
if 3” is a no go I will take 2 1/2”
I’m planning on using block hugger headers on a big block and dumping out the back in the stock location.
s/s or ceramic coated is ok, but want a good heavy gauge

 

[BBShark]

I have a stainless 2 1/2" Magnaflow with crossover. Not sure if its still available.

This is the best picture I have:

 

[COLE SWEAT]

Where did you get this?

 

[BBShark]

Probably Jegs or Summit. Probably bought it 10 years ago.

 

[Twin_Turbo]

Build from scratch. Weld els and pipes. I use stainless. 2.75 is about the biggest that fits through a 2 hole x member wuthout banging

 

[COLE SWEAT]

I don’t weld, i was hoping on something made to fit.
what mufflers are those and what motor do you have.
manifolds?

 

[Twin_Turbo]

Mufflers are home built absorpion style. Motor is a 327, stainless shorty block huggers.

It's a restomod 63 convertible I built 15 or so years ago.

 

[COLE SWEAT]

I’m looking to do the shorty block huggers too, but on a 468 big block
was going to use long tube headers but everything is just too tight

 

[BBShark]

I was going to use shorties on a BB but changed my mind and used mid length. Huge mistake. It required clearancing the foot well on both sides.

Stick with the shorty.

 

[COLE SWEAT]

I am
i have hooker super comps on the chassis now and everything is to close, starter, steering box.
everything is going to cook. The collector is so close to the cross member, I will have to put some crazy angles on the pipe to get them through.

so where to buy preformed exhaust, no mufflers and good quality thick material