Long Overdue Progress! Making New Door Panels 12/8/24
- Thread starter BBShark
- Start date
Interesting. Thanks for the tip.
First test fit to the actual door. Some things to clean up and covers to bridge the latch and the power connector block, but very close:
Frame completed with component placement:
Frame completed with component placement:
Last edited:
Installing Mag daddy door "clips". This is going to work out well since I have to take the panels on and off multiple times. I cut a rectangular pocket first, and glued a thin ABS sheet with a hole in it:
Then I covered the back with a fiber sheet that loosely captured the magnet. Fom pad on the back to push the magnet out.
Done:
Then I covered the back with a fiber sheet that loosely captured the magnet. Fom pad on the back to push the magnet out.
Done:
