Long Overdue Progress! Rebuild Doors & Latch Mods 10/02/24

Yesterday I partially re-installed the window in the door. 1968 is a 1 year only setup so the sequence is different but I think its in. The most difficult thing was trying to bolt the window channel to the window while its inside the door. Next is the regulator.
 
Both windows are in and working well. After cleaning all the lithium grease off the windows (from greasing the tracks), I noticed some pretty severe scratches on the inside of the glass. I took a look at some of the YT videos on polishing the scratches but there were no videos on polishing the inside concave surface, only the outside.

Anyone here ever done that?
 
Still working on the electric unlatching. Turning my attention to door panels. I am thinking I could use C6 panels to at least complete the center of the panel (including the handles. And fabricate/use the C3 panel perimeter, then "morphing" the two together.

1730562035683.png
 
BBShark said:
I took a look at some of the YT videos on polishing the scratches but there were no videos on polishing the inside concave surface, only the outside.

Anyone here ever done that?
Click to expand...
Looks like guys use a foam pad with some kind of polishing compound. Seems to me for a concave side just use a smaller diameter pad.

Good idea on repurposing c6 door panels. Be interesting to see how that turns out.
 
I found a 3" pad that I think will work.

The C6 panels are similar size to the C3 door. And made in two pieces (black part on top is attached). That will work well so I can get to the latch without taking the entire panel off.

1730805522701.png

C3 Panel Stripped:
1730926236914.png
 
You must log in or register to reply here.

Latest posts

Back
Top