Switching to PCV valve?

[Twin_Turbo]

http://www.ebay.com/itm/RACING-VACU...8&item=170990805304&pt=Race_Car_Parts&vxp=mtr

 

[kwplot34]

Here is a cure to the PCV. Front left on the motor connected to the valve cover by that big black hose.

Is that a additionnal vacuum pump?
I see you have it on one side, what's on the other?
So you only need one (assuming both cover can equalize pressure)?
Yup, I'm that newbie :blush:

PS: I love you spark wire loom, I thought nothing would work with this type of cover.
PS(2): very nice/neat engine setup.

As TT said that is a vacuum pump and a regulator valve onthe other valve cover, it is set not to pull over 10in hg.
You only need 1 pump.
Wire looms are from billet specialist.
Thank you. It is pretty clean under the hood.put that motor in last summer.

 

[kwplot34]

I got my pump from GZ motor sports. Came with everything needed for installation, including
Brackets.cost was around $1, 000.00

 

[denpo]

...I love you spark wire loom, I thought nothing would work with this type of

...Wire looms are from billet specialist.

Ahh, I get it now, it's a typical loom that goes an the base of the cover, the trick it the special cover bolt.
So obvious now I see it.:amazed:

 

[kwplot34]

...I love you spark wire loom, I thought nothing would work with this type of

...Wire looms are from billet specialist.

Ahh, I get it now, it's a typical loom that goes an the base of the cover, the trick it the special cover bolt.
So obvious now I see it.:amazed:

That is the trick. The other trick is, I had to make those special bolts